Juno 66– Pulse wave not working post-install, suggestions?

frontpage Forums Product questions and support Juno 66– Pulse wave not working post-install, suggestions?

  • This topic has 2 replies, 1 voice, and was last updated 5 years ago by Anonymous.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #9538
    Anonymous
    #9539
    tubbutec
    Keymaster

    Hi,

    you can find a Juno-6 service manual here:
    http://fa.utfs.org/diy/rolandjuno6/Rola … ervice.pdf

    the pulse width signal comes from the back panel via a connector. The signal is called ‘MULTI PWM CV’, seen on page 15 coming from panel board A.

    A first step would be to check the connector and measure, if the signal arrives in the voice board. You should be able to use a multimeter for that.

    #9540
    Anonymous
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.