Reply To: Juno 66– Pulse wave not working post-install, suggestions?

frontpage Forums Product questions and support Juno 66– Pulse wave not working post-install, suggestions? Reply To: Juno 66– Pulse wave not working post-install, suggestions?

#9539
tubbutec
Keymaster

Hi,

you can find a Juno-6 service manual here:
http://fa.utfs.org/diy/rolandjuno6/Rola … ervice.pdf

the pulse width signal comes from the back panel via a connector. The signal is called ‘MULTI PWM CV’, seen on page 15 coming from panel board A.

A first step would be to check the connector and measure, if the signal arrives in the voice board. You should be able to use a multimeter for that.