Reply To: µTune question

frontpage Forums Product questions and support µTune µTune question Reply To: µTune question

#9026
tubbutec
Keymaster

timoka wrote:
ah great i had a similar problem with the scaling.
so in general, if using analog sequencer or ribbon controllers which mostly start at 0v to 5v or higher, it’s best to set everything at 0, middle note and voltage?
is it possible to have this saved as default configuration?
The optimal setting always depends on your preference. Think of the middle note as the starting point of your scale. As mentioned in the manual, this is the point with constant pitch, no matter what scale you are using.
If you have an input range of 0-5V (usually that means note number 0 to 60) you could put the starting point at 0, but maybe 2V / note 24 suits you better. You could then pitch up and down from there..