Select Midi output
Select Midi input
CONFIGURATOR
|
FIRMWARE UPDATE
Load firmware file:
Use recovery mode:
(See user manual)
Start firmware update
uniMatrix configurator
Send configuration
via Midi
Save Configuration
to File
Load configuration:
Export as sysex
to File
Synthesizer name:
Description:
Midi config
Global midi input channel
1:
Global midi out channel:
1:
Midi base note:
1:
Matrix config:
Matrix mode
Select the matrix mode. Note, that input + output mode is slower and might not work with your machine
OFF
Midi Input
Midi output
Midi input and output
Midi input and output v2
Midi input and output switch
qeqweqweqweqwe
Use Adress mode
If adress signals for the matrix outputs are available, this mode can read them directly.
Use Enable signal
There is an additional enable signal in addition to the adress signals
Enable Polarity:
Active high: Enable signal is active high
Active low: Enable signal is active low
Active High
Active low
Adress-bits:
Sense / Output count:
Stimulus / Input Count:
read delay:
Delay before reading the bus. Adjust carefully.
x 50ns
Debounce time:
Debounce time constant. Used for midi out.
ms
Short-push time:
If short push is selected for a matrix contact, time the contact is pressed.
ms
Polarity:
Active high: Matrix outputs are active high, typically pulldowns at the inputs.
Active low: Matrix outputs are active low, typically pullups at the inputs.
Active High
Active low
Address
decoder
INPUTS
A0
A1
(EN)
A0
A1
(EN)
Pull up or down
resistors
Contacts
Original Matrix circuit
Stimulus
Sense
OUTPUTS
INPUTS
Pull up or down
resistors
Contacts
Original Matrix circuit
Stimulus
Sense
waerware
Matrix settings
OUT1
OUT2
OUT3
OUT4
OUT5
OUT6
OUT7
OUT8
OUT9
OUT10
OUT11
OUT12
OUT13
OUT14
OUT15
OUT16
asasasasasas
Create report
Switch table editor
This editor can help to populate the key contact matrix with the correct midi notes.
Multiple methods are available: Forward, Backward, Rotated and Rotated backward.
furthermore, modifiers are provided to shift the populated notes, increase or decrease them
Number of notes to populate:
Number of key contacts that are populated with Notes
Populate:
FWD
BACKW
Rotated
Rotated reversed
Modifiers
-->
<--
+1
-1
table generated
CV-out config
Configuration of the two CV-outputs provided by uniMatrix
CV-out
Mapping
Map this CV-output to one of several Midi message sources.
Note/CC
Note or CC number the output reacts to
Invert
Invert the CV output
1
None
Controller
Velocity
Aftertouch
Channel Pressure
2
None
Controller
Velocity
Aftertouch
Channel Pressure